2-stroke tuning for max power no overheat

[Alan]

Hey, what jetting, timing, and cooling tricks do you use to max out power without blowing up your engine? I'm looking for setup ideas.

 

[sharpedge]

Start with slightly richer settings, then adjust based on plug readings. Advance the timing a bit, but keep an eye on temps. Good airflow and a clean cooling system help a lot.

 

[Marluxia_Assassin]

Best trick I learned: don’t chase perfect idle, chase clean midrange. Most saws die from lean mids, not top-end. Set your H jet where it blubbers slightly under no load. You’ll lose a couple hundred RPM, but gain a lot of piston life. Also, always run fresh fuel coz old mix cooks bearings.

 

[Odd Rod Todd]

Best trick I learned: don’t chase perfect idle, chase clean midrange. Most saws die from lean mids, not top-end. Set your H jet where it blubbers slightly under no load. You’ll lose a couple hundred RPM, but gain a lot of piston life. Also, always run fresh fuel coz old mix cooks bearings.

Probably the simplest (best) explanation I've heard in a while...